Panic Button Setup & Installation

Step 1. 

Black wire (Earth) linked from V- to COM 

Step 2.

Red wire (Positive feed) onto V+

Step 3.

Blue wire (Normally open) to calamp Negative trigger out 

Step 4. 

Follow steps below to set to “Momentary mode”, This allows the unit to pair with the Remote.

1. Connect to power and earth ready for programming. 

1. Press the learning button (on the receiver) 1 time. The indicator LED on the receiver will light up.
2. Press the “A” button on the remote transmitter. The indicator LED on the receiver will flash several times and then the light will go off. This is now the transmitter paired with the receiver.
3. As a sanity check, press the “A” button after pairing and you will hear the relay click within the receiver and a red led will light up. 

Step 5.

Put receiver unit into casing.

Step 6.

Close casing.

Step 7. 

Connect the red wire from the receiver to the red wire of the calamp wiring.

Step 8.

Connect the black wire from the receiver to the black wire of the calamp wiring.

Step 9. 

Connect the blue wire from the receiver to the blue wire of the calamp wiring.

Step 10.

Calamp unit installed to power source on vehicle as normal.

Step 11. 

 press the "A" button on the remote, this should then send through both an email and a popup notification on the selected users account.